Gasboy TopKAT PLUS - Manual (Page 27)

MDE-5013C TopKAT™ PLUS Installation Manual · February 2015 Page 3-1
General TopKAT PLUS Installation Procedures
3 – TopKAT PLUS Installation Procedures
General
TopKAT PLUS units can be supplied factory mounted on an Atlas pump/dispenser or with a
pedestal for interface to mechanical or electronic register pumps/dispensers. This section
provides installation procedures for both types.
These procedures include:
• TopKAT PLUS box installation
• Wiring
• Post installation check
Installation Specifications
General
Installation procedures and requirements depend, to some extent, on the specific fuel dispenser
models. Therefore, use the information in this section to develop factory installation plans for
each specific dispenser or suction pump.
Precautions and Safety Notes
Before actual installation activities, carefully observe the following precautions and safety
notes:
Before installing or servicing equipment, carefully observe the warnings and precautions
provided in
“Important Safety Information” on page 2-1 .
WARNING
• Ensure that actual installation is performed by experienced personnel as required by the
National Fire Protection Association-30 (NFPA-30) “Flammable and Combustible Liquids
Code”, NFPA-30A “Code for Motor Fuel Dispensing Facilities and Repair Garages”,
NFPA-70A
® , National Electric Code (NEC), federal, state, and local codes, and any other
applicable safety codes and regulations.
• System power may come from more than one source. Disconnect all power sources,
including pumps, before attempting to work on the system.
• Do not connect power to the TopKAT PLUS or pump, until the complete installation is
inspected and certified.