Online supervisor sequence – Gasboy TopKAT Online Operation Manual User Manual
Page 50
![background image](https://www.manualsdir.com/files/787533/content/doc050.png)
Appendix A: Prompts at the Hertz Online TopKAT
Online Supervisor Sequence
Page A-2
MDE-4589 PC TopKAT™ Online Operation and Setup Manual · August 2010
If a Driver Record is not found, the display shows
“NO RECORD FOUND
please reenter”.
There are three retries. After the third unsuccessful attempt, the display shows “NO RECORD
FOUND”.
This is displayed for 3 seconds and the sequence is terminated.
If a Driver Record is not received within 15 seconds, the TopKAT system reverts to Fallback
Scenario 3 described in section
on
.
If a successful Driver Number entry has been made, the display shows “ENTER PUMP #”.
The remainder of the sequence is identical to the current TopKAT system.
Online Supervisor Sequence
The display will scroll to “ENTER EQUIPMENT #” since Keyless is the only entry mode. In
this case, the Equipment Number is the number assigned to the Supervisor. Upon selecting the
equipment number, the display shows:
“EQUIPMENT #”
(the selected number is shown here)
Press Enter and the display shows
“Retrieving data.
please wait”.
The Equipment number is sent to the PC, which returns the Equipment Record to the TopKAT
system.
If an Equipment Record is not found, the display shows “NO EQUIPMENT RECORD”.
This is displayed for 3 seconds and the sequence is terminated.
If an Equipment Record is not received within 15 seconds, the TopKAT system reverts to
Fallback Scenario 2 described in section
.
If a successful Equipment Number entry has been made, the display then shows
“SUPERVISOR”.
This is displayed for 3 seconds after which the display shows “ENTER EQUIPMENT #”.