Gasboy CFN III Quick Reference Guide v3.3 - Manual (Page 57)

CFN III Quick Reference
MDE-4483 CFN III Quick Reference Guide v3.3 · August 2005 Page 53
Tank Gauge
Veeder-Root CPU Board
TLS 250 and TLS 250i
DIP Switch Bank 1
Position & Definition Setting(*=customary)
1-3 interboard
communications *always closed
4 parity *always closed=odd
5 security code *always closed=enable
TLS 350
9600, odd, 1 stop bit, 7 data bits
Enable Security Code:
Yes
Auto Transmit Message: Disabled
Tank Monitor Security 000001 (assumes only
Code (Address): one monitor on system)
EoT Character: Enable
Cabling the TLS-350
TLS 350R
1. RS-232 Security Code: 000001
2. RS-232 End of Message: Enabled
System Requirements
Console must have “Send All Messages Feature”,
page 5 of SYS_PAR.
Non-blended dispensers are supported.
All Profit Point Broadcast Messaging enabled.
Gasboy Junction Box P/N C05020.
Interface Module Hardware Configuration.
Baud
Rate
DATA
Bits
CFN
Parity
SW1 SW2
9600 7 odd 1,2,4=closed
3=open
all open
Cabling the TLS-350R for with BIR
The TLS must be connected on Island Loop 1 to
receive BIR data. See TLS-350 illustration.
ECPU Board Battery Switch ON (SW1)
HRM Features (Europe Only) - Enabled
(DIP Switch 3 in the Closed position)
Other areas - disabled (disabled for CFN)
(DIP Switch 3 in the OPEN position)
RS-232 Security Code-Disabled
(DIP Switch 2 in the OPEN position)
Front Panel Security Code - Disabled
(DIP Switch 1 in the CLOSED position,
2 OPEN, 3 OPEN, 4 UNUSED)
DIP rocker switch 4 - Unused
Battery Backup Switch - OFF (down)
Wiring to the Junction Box
Note: if cable must be shortened, remove excess at
the TLS end.
For further installation instructions, refer to the
VeederRoot manual titled “Gasboy CFN TLS-
350/TLS-350R Systems Setup.”