Gasboy CFN III Quick Reference Guide v3.3 - Manual (Page 22)

CFN III Quick Reference
Page 18 MDE-4483 CFN III Quick Reference Guide v3.3 · August 2005
%I Current site ID.
%J 0=journal.log is up to date.
1=journal.log is not up to date.
%K Position of console keyswitch:
0 = off
1 = on
4 = supervisor
8 = manager
%M# Miscellaneous options where # stands for:
0 = non-resettable totals
1 = returns the initial drawer
balance in SYS_PAR
2 = transaction number of first
transaction in file
3 = transaction number of last
transaction in file
4 = status of bank modem (0=down,
1=available, 3=connected)
5 = status of CFN modem (0=down,
1=available, 2=dialing,
3=connected but not logged in,
4=logged in)
6 = if the parameter is enabled
for unique shift numbers for
each console, returns a 1; if
disabled, returns a zero
7C# = if the parameter is enabled
for unique shift numbers for
each console, returns the
shift number of console #;
if disabled, returns the
system’s shift number. (The #
can be replaced by a %a-%z
user variable to allow
variable selection of the
console number.
8C# = if the parameter is enabled
for unique shift numbers for
each console, returns the
shift sequence number of
console #; if disabled,
returns the system’s shift
sequence number.
(The # can be replaced by a
%a-%z user variable to allow
variable selection of the
console number.
9 = returns one if configured for
a CRT; otherwise, returns
zero.
%P Permission level of user currently signed on.
%Q Site shift sequence number; each site shift
change increments this number.
%R Site run level:
0 = running
1 = blocking new transactions
2 = stopped
3 = emergency stopped
4 = memory full
5 = crashed
%S Current site shift number (1, 2, or 3).
%T Time (HH:MM AM/PM).
%U User number of user currently signed on.
%V Site version number.
%W Day of week-Sun, Mon, Tue, Wed, Thu, Fri,
Sat
%Y Date-time (YYMMDDHHMM)
%a-
%z
User string variables set by SET_VAR; up to
118 characters long.
.EXE
Executable programs used to carry out or perform an
operation. These have an .EXE ending.
BATCH Executes processes on the Site Controller
through the PC.
SC3 local Site Controller command terminal
window on the PC.
SC3SHELL Site Controller command shell program
on the PC.
CFN3 Backup
These are run from an NT command window, not the
SC3 window.
BACKUP NT command file which takes all files
excluding .BINs, .EXEs, and HTML files placing
them onto floppy diskette(s).
RESTORE NT command file which extracts the
compressed files created with BACKUP and returns
them to SC3 directory. Not the same as the site’s own
RESTORE described earlier.