Gasboy CFN III Quick Reference Guide v3.3 - Manual (Page 56)

CFN III Quick Reference
Page 52 MDE-4483 CFN III Quick Reference Guide v3.3 · August 2005
CFN3 Pump Configuration to Gilbarco
Notes: Pump limits and card limits must be in dollars,
not volume; for a cash/credit pump ($/Cr), the limit
must be $999. Grade assignments must be entered as
hose numbers.
In the PUMP configuration program, in submenu
3, set the following options:
Gilbarco type Options to set
Highline (old) 6,9
Highline 9
Highline$/Cr 3,9
MPD 1,5,9
MPD $/Cr 1,3,5,9
Wayne
The cable that connects the Wayne controller with
port 4, 5, or 6 of the CFN3 is part number C06006.
The pins in the cable are wired like this:
The Wayne controller must be set at 1200 baud.
For Wayne pumps:
• the cash price must be lower than or equal to the
credit price.
• the pump limit must be $999 for the cash/credit
selection to work.
• all Wayne dispensers must be configured in
sequential, consecutive order. All Wayne
dispensers must be addressed as starting with
number 1, regardless of the actual pump numbers
that they are configured with in the Site
Controller.
• in the Wayne Data Distribution Box, any
switches that are not wired to a dispenser must
be in the Bypass position.
For non-blenders:
• each hose must be assigned a price code in
ranges 1-5, 11-15, 21-25, 31-35; all hoses on a
pump must be in the same decade.
For all blenders:
• use price codes 6-9, 16-19, 26-29, 36-39 for
blended hoses. Use price codes 4, 14, 24, 34 for
low feedstock (non-blended hoses). Use price
codes 5, 15, 25, 35 for high feedstock (non-
blended hoses).
• product names for products in blended hoses
should contain blend rate (for example, blended
40%, using a percent sign); do not use a percent
sign in non-blended hoses.
For fixed blenders:
• hose 1 is always a non-blended, low-feedstock
hose and must have price code 4 (or 14 or 24 or
34). Hose 3 is always a non-blended, high-feed-
stock hose and must have price code 5 (or 15 or
25 or 35). Hose 2 is the blended hose and must
have a price code in ranges 6-9, 16-19, 26-29,
36-39.
For variable 5-product blenders:
• hoses 1-5 must use price codes 4-9, 14-19, 24-
29, 34-39, with no repeats.
For variable 3-product blenders:
• assign 5 hoses, but assign price code 99 to hoses
2 and 4 since the system uses only hoses 1, 3,
and 5.
CFN3 Pump Configuration to Wayne
In the PUMP configuration program, in submenu 3,
set the following options:
Wayne type Options to set
MPD 1,2,5,7,9
MPD $/Cr 1,2,3,5,7,9
Blender 1,2,5,7,9,12,19*
Blender $/Cr 1,2,3,5,7,9,12
* Select option 19 only if there are grade buttons to
press.
DIN
Male DB-25S
Connector
1 20
2 5
7 4
8 8
6 6
5 2
3 3
4 7