Gasboy CFN III Quick Reference Guide v3.3 - Manual (Page 20)

CFN III Quick Reference
Page 16 MDE-4483 CFN III Quick Reference Guide v3.3 · August 2005
SUbtract INventor y (141) subtracts from inventory
for a product.
Option: C
SUbtract TAnk (72) subtracts from tank inventory
counter.
Option: C
SYSBACK disk-based command to back up all
system tables in RAM, except transactions, to the
SYSBACK.DTA file.
SYS_PAR disk-based configuration program for
system parameters; main configuration program for
Site Controller.
Options: [-P][-V] [filename]
-P print current configuration
-V display in TTY form if port is configured as
a CRT in the system parameters, or vice versa.
SYSte m (160) changes from the CFN3 prompt (R*)
to the NT operating system prompt. Type EXIT to
return to the CFN3 prompt. Designed for use from a
remote site only.
TABLE disk-based configuration program for data
table sizes.
Options: [-P][-V] [filename]
-P print current configuration
-V display in TTY form if port is configured as
a CRT in the system parameters, or vice versa
TAX disk-based tax table entry program.
Options: [;[C][I]] [-P | -R | -?]
;C chain entries: keep looping back to the
initial prompt
;I reconstruct the tax rate table
-P print tax table summary
-R print tax table in raw form used by
RESTORE
-? run in tutorial mode
TEst PCu (73) tests a pump control unit’s memory.
TRANBACK disk-based command to back up
transaction data to the TRANBACK.DTA file.
TREE disk-based command to print directory
structure of the R drive only.
TRFMT disk-based configuration program for local
transaction format.
Options: [-P][-V] [filename]
-P print current configuration
-V display in TTY form if port is configured as
a CRT in the system parameters, or vice versa
TYpe (5) prints the contents of a file.
Option: A
A option prints past the MS-DOS end-of-file
marker
Unlock CArd (74) validates a card.
Options: C A
A option clears card file and sets negative
lockout
variable a shift-change command to list the state of
the shift sequence and shift number for the system
and for each console.
WHERE disk-based command to print current
directory.