Comtech EF Data MDX420 SkyWire Manual - Manual (Page 80)

MDX420 SkyWire™ Satellite Network Gateway SkyWire Controller (GUI)
MN-MDX420 Revision 6 7–24
To view the detailed alarms of the gateway common hardware, select the Common tab. The
Detailed Alarms screen for the gateway common equipment (Figure 7.4.6-3) is shown.
Figure 7.4.6-3
Major Alarms:
Glue FPGA Indicates Glue FPGA configuration failure.
Terr. Interface FPGA Indicates an Interface Card FPGA configuration failure.
Minor Alarms:
+1.2V Displays the measured voltage of the 1.2 Volt power bus located inside
the gateway.
+1.8V Displays the measured voltage of the 1.8 Volt power bus located inside
the gateway.
+3.3V Displays the measured voltage of the +3.3 Volt power bus located inside
the gateway.
+5V Displays the measured voltage of the +5 Volt power bus located inside
the gateway.
+12V Displays the measured voltage of the +12 Volt power bus located inside
the gateway.
+24V Displays the measured voltage of the +24 Volt power bus located inside
the gateway.
LNB Voltage Indicates that the LNB voltage is out of specification
LNB Current Indicates that the LNB Current is out of specification.
Terr. Ethernet Link Indicates lack of activity on the gateway Ethernet Data port.