Comtech EF Data MDX420 SkyWire Manual - Manual (Page 52)

MDX420 SkyWire™ Satellite Network Gateway Terminal Screens
MN-MDX420 Revision 6 6–14
6.2.4.9 SNMP V1 & V2 Controls
SNMP VERSION {V1 & V2, V3}
This selection controls the SNMP Version that will be used in messaging between
the equipment and its host.
When V1 & V2 is used, RD COMMUNITY and RDWR COMMUNITY are used to
determine the authorization of an incoming message.
TRAP VERSION {V1, V2}
This controls the type of message format used when a message trap is generated
by the equipment and bound for a SNMP Host. Messages will only be sent if the
gateway has been authorized to do so.
TRAP
AUTHORIZATION {TRAPS OFF, TRAPS ON}
This controls the type of message format used when a message trap is generated
by the equipment and bound for a SNMP host. Messages will only be sent if the
gateway has been authorized to do so.
V1&2 RD
COMMUNITY {16 characters of name}
This menu is only displayed when SNMP VERSION is set to V1 & V2. This is the
community that a host must be acting within when an OID variable is requested
by a V1/V2 SNMP message. The defaulted setting is “Public”.
V1&2 RDWR
COMMUNITY {16 characters of name}
This menu is only displayed when SNMP VERSION is set to V1 & V2.
This is the community that a host must be acting within when an OID variable is
being changed by a V1/V2 SNMP message. The defaulted setting is “public”.
PRIMARY TRAP
HOST {xxx.xxx.xxx.xxx}
This specifies the IP address of the "public" SNMP host. Trap messages are sent
to this address when a trap is generated by the equipment.