Comtech EF Data MDX420 SkyWire Manual - Manual (Page 62)

MDX420 SkyWire™ Satellite Network Gateway SkyWire Controller (GUI)
MN-MDX420 Revision 6 7–6
7.3.1.3.2 SNMPV3
When selecting SNMPv3, the gateway enables administrative controls and allows limited access
to all other users. In this mode, the administrator retains access to all parameters but can limit
access to certain users by assigning them as Viewers, Operators, or Administrators and must be
set to match the configuration as set by the Service port (refer to section 6.2.4.10). Configuring
SNMP Version 3 will be described later in this chapter.
7.3.1.4 Polling Interval
The SkyWire Controller will poll the gateway based on the setting of the Polling Internal (in
seconds). The default setting is 2 seconds and an be changed by the user to the desired polling
interval
Click on the Save button to store the destination profile for easy future access.
Once the user is authenticated, a quick summary (Figure 7.3.1.4) of the burst demodulators and
network status, event logs, and summary faults is displayed.