Comtech EF Data MDX420 SkyWire Manual - Manual (Page 79)

MDX420 SkyWire™ Satellite Network Gateway SkyWire Controller (GUI)
MN-MDX420 Revision 6 7–23
Figure 7.4.6-2
 Major
Alarms:
o Mod FPGA Indicates a transmit FPGA configuration failure.
o Encoder FPGA Indicates a transmit encoder configuration failure.
o LO Synthesizer Indicates that the Tx L-Band Synthesizer is not locked. This alarm
will flash on during certain gateway parameter changes. A solid indication points
toward a configuration problem within the gateway.
o Share Group Config The burst modulator and that active listener burst demodulator
satellite configuration parameters do not match
 Minor
Alarms:
o Output Level Indicates that the Output Level is out of specification.
o BUC Voltage Indicates that the BUC voltage is out of specification
o BUC Current Indicates that the BUC Current is out of specification.
o Mesh Authorization Indicates the Gateway/Authorization ID number cannot be detected
on the mesh network.
o Carrier Level Cal The gateway has not been properly calibrated
o DC Offset Cal The gateway has not been properly calibrated