Comtech EF Data MDX420 SkyWire Manual User Manual

Page 51

MDX420 SkyWire™ Satellite Network Gateway

Terminal Screens

MN-MDX420 Revision 6

6–13

IP MASK

{ddd.ddd.ddd.ddd} Decimal Mask
The IP Address Mask of the local network. The mask is expressed in a hexadecimal
format, and must be a valid TCP/IP Mask. This field should be set before changes are
made to the Gateway or Router Address.

MODEM IP
ADDR

{ddd.ddd.ddd.ddd} Decimal Mask
The IP Address of the gateway. This address should be consistent for the mask defined.
This address is expressed in hexadecimal format. Broadcast and loop back addresses
will not be allowed. These are addresses with all subnet bits set to 0’s or 1’s.

SERVER IP
ADDR

{ddd.ddd.ddd.ddd} Decimal Address
The IP Address of the Boot Server and the address of the SNMP Trap Server when
SNMP is active. If a server is used and there is no local router, this address must be
consistent with the gateway address. If a router has been specified, the address is
presumed to be reachable via the router. Broadcast and loop back addresses will not be
allowed. These are addresses with all subnet bits set to 0’s or 1’s.

ROUTER IP
ADDR

{ddd.ddd.ddd.ddd} Decimal Address
The IP Address of the Local Network Router. If a router is present on the local network,
this address must be consistent with the IP Mask and the subnet of the gateway. If no
router is present, then the address should be set to a foreign address. This address is
expressed in hexadecimal format.
Broadcast and loop back addresses will not be allowed. These are addresses with all
subnet bits set to 0’s or 1’s.

Modem
Ether Addr

{hhhhhhhhhhhh}
Displays the Ethernet address of the device. Set at the factory and is a unique identifier
for the Ethernet physical interface.

ETHER
RATE

{10/100 MBPS/Auto Negotiate}
The data rate for the local Ethernet Interface. 10/100 Mbps/Auto Sensing – for 10 or 100
Base-T in either half-duplex or full duplex.

FTP User ID

{XXXXXXXXXXXXXX}
The FTP USER ID and Password will be shared by all sites transmitting into the same
share group regardless of what is entered here. This setting is only used by the first site
that starts the share group. Once in a share group any changes to the User ID or
Password will be communicated to all sites in that share group automatically. The default
User ID is: user

FTP
Password