Comtech EF Data MDX420 SkyWire Manual - Manual (Page 63)

MDX420 SkyWire™ Satellite Network Gateway SkyWire Controller (GUI)
MN-MDX420 Revision 6 7–7
7.4 SkyWire Controller Configure Tab
After successfully logging into the configuration controller, the user must first configure the
MDX420 satellite link parameters to the desired setting. Satellite Link menus include but are not
limited to:
Figure 7.4 SkyWire Configuration Controller
 RF
Frequency
 IF
Frequency
 Modulation
 Inner FEC (Forward Error Correction)
 Standard or Enhanced Performance
 Data
Rate
 Symbol
Rate
 Block Up Converter (BUC)
 Low Noise Block (LNB) converter
NOTE: The MDX420 allows the user to determine if the frequency control for the burst
modulator and burst demodulator are either IF or RF and if the information rate control is
to be entered as symbol rate or data rate. Refer to Section 7.4 for control options settings.
Using the SkyWire top-level menu system, select the Configure / Satellite Link / Modulator menu
(Figure 7.4-1).