Comtech EF Data MDX420 SkyWire Manual - Manual (Page 48)

MDX420 SkyWire™ Satellite Network Gateway Terminal Screens
MN-MDX420 Revision 6 6–10
6.2.4.6 Modulator Alarms
The Alarms menu description:
 CURR - Current alarm status (PASS, FAIL)
 LTCH - Latched alarm status - (PASS, FAIL) displays a fault that used to exist.
 Unmasked - Displays all alarms and follows standard alarm protocol
 Masked - Hides the specified alarm and allows to unit function as if no alarm existed.
MODULATOR ALARM STATUS
MOD FPGA {Pass/Fail, Unmasked/Masked}
Indicates a transmit FPGA configuration failure.
ENCODER
FPGA {Pass/Fail, Unmasked/Masked}
Indicates a transmit encoder configuration failure.
IF LO
SYNTH {Pass/Fail, Unmasked/Masked}
Indicates that the Tx L-Band Synthesizer is not locked. This alarm will flash on during
certain gateway parameter changes. A solid indication points toward a configuration
problem within the gateway.
OUTPUT
LEVEL {Pass/Fail, Unmasked/Masked}
Indicates that the Output Level is out of specification.
BUC
VOLTAGE {Pass/Fail, Unmasked/Masked}
Indicates that the BUC voltage is out of specification
BUC
CURRENT {Pass/Fail, Unmasked/Masked}
Indicates that the BUC Current is out of specification.
CLEAR
LATCHED Allows the user to reset the latched alarms by selecting
MESH
AUTH Indicates the Gateway/Authorization ID number cannot be detected on the mesh network.
This alarm is active as soon as the modulator is enabled when there is a corresponding
non “0” demod associated with the modulator (see section 6.1.4.2). This alarm will clear
only when the unit has successfully joined a share group and is part of the network.