Comtech EF Data KPA - Manual (Page 75)

KPA Ku-Band Indoor Solid-State Power Amplifier Revision 1
Ethernet Management MN/KPA.IOM
6–13
6.5.4.3.2 Config | Utility page
Figure 6-6. Config | Utility page
The ‘Config | Utility’ page (Figure 6-6) is used to adjust or customize a variety of KPA
operation features.
Note the following:
• Date: The user may enter a date using MM/DD/YY format
(where MM = month [01 to 12], DD = day [01 to 31], and YY = year [00 to 99]).
• Time: The user may enter a time using HH:MM:SS format
(where HH = hour [00 to 23], MM = minutes [00 to 59], and SS = seconds [00 to 59]).
Once the desired date and time have been entered in this section, click [Change
Date/Time] as needed to save these changes.
• Forward RF Power Monitor Offset (dBm) and Reverse RF Power Monitor Offset
(dBm): For either, enter an offset value (in dBm) from -6.0 to +6.0.
Once the desired offsets have been entered in this section, click [Change Offsets] as
needed to save these changes.
• Circuit ID: The user may enter a Circuit ID string of up to 24 characters.
Once the desired string has been entered in this section, click [Change CID] as needed to
save this change.
• Reference Frequency Adjust: The user may enter an adjustment value from 0 to 255.
Once the desired value has been entered in this section, click [Adjust] as needed to save
this change.