Comtech EF Data KPA - Manual (Page 15)

KPA Ku-Band Indoor Solid-State Power Amplifier Revision 1
Preface MN/KPA.IOM
xi
Electrical Safety and Compliance
Electromagnetic Compatibility (EMC) Compliance
IMPORTANT
Properly shielded cables for DATA I/O are required in order to meet the European
Electromagnetic Compatibility (EMC) Directive (EN55022, EN50082-1). More specifically,
these cables must be shielded from end-to-end, ensuring a continuous ground shield.
In accordance with European Directive 2004/108/EEC, the KPA family of products has been
shown, by independent testing, to comply with the following standards:
Emissions: EN 55022 Class B – Limits and Methods of Measurement of Radio
Interference Characteristics of Information Technology Equipment.
(Also tested to FCC Part 15 Class B.)
Immunity: EN 55024 – Information Technology Equipment: Immunity Characteristics,
Limits, and Methods of Measurement.
European Low Voltage Directive (LVD)
The following information is applicable for the European Low Voltage Directive (2006/95/EC):
Symbol Description
Type of power cord required for use in the European Community.
!
CAUTION: Double-pole/Neutral Fusing
ACHTUNG: Zweipolige bzw. Neutralleiter-Sicherung
WARNING
This product contains a Lithium Battery. DANGER OF EXPLOSION EXISTS if the
battery is incorrectly replaced. Replace only with the same or equivalent type
recommended by the manufacturer. Dispose of used batteries in accordance with
local and national regulations
CAUTION
This equipment has been designed to minimize exposure of personnel to hazards. The
operators and technicians must:
• Know how to work around, with, and on high voltage and high RF power level
equipment.
• Exercise every precaution to ensure personnel safety.
• Exercise extreme care when working near high voltages/high RF power level
equipment.
• Be familiar with the warnings presented in this manual.
• Disconnect the power supply cord before servicing the ISSPA.