Comtech EF Data KPA - Manual (Page 114)

KPA Ku-Band Indoor Solid-State Power Amplifier Revision 1
Appendix C MN/KPA.IOM
C–18
C.7.1 Old Utility Commands
Time Set Time:
Confirmation:
Retrieve Time:
Confirmation:
>DEV/TIM_hh:mm:ss 'cr''lf']
>DEV/TIM_hh:mm:ss 'cr''lf'] Where: hh = Hour
mm = Minutes
ss = Seconds
Note: 24-hour military is used.
Date Set Date:
Confirmation:
>DEV/DAT_mm/dd/yy/'cr''lf'] Where: mm = Month dd = Day yy = Year
Physical Address Set Physical Address :
Confirmation:
Retrieve Physical
Address:
Confirmation:
>DEV/SPA_xxx'cr''lf']
>DEV/SPA_xxx'cr''lf'] Where: xxx = 1 to 255
The default physical address is 1.
Baud Rate Set Baud Rate:
Confirmation:
Retrieve Baud Rate:
Confirmation:
>DEV/SBR_xxxx'cr''lf']
>DEV/SBR_xxxx'cr''lf'] Where: xxxx = 300, 1200, 2400, 4800, or 9600
The default baud rate is 9600.
Parity Bit Set Parity Bit:
Confirmation:
Retrieve Parity Bit:
Confirmation:
>DEV/SPB_xxxx'cr''lf']
DEV/SPB_'cr'
DEV/SPB_xxxx'cr''lf'] Where: xxxx = Odd or Even
The default parity is Even.
LCD Contrast Set Contrast:
Confirmation:
Retrieve Contrast:
Confirmation:
>DEV/CON_xx'cr''lf']
>DEV/CON_xx'cr''lf'] Where: xx = 0 to 30
The default is contrast 15.
LCD Brightness Set Brightness:
Confirmation:
Retrieve Brightness:
Confirmation:
>DEV/LCD_xx'cr''lf']
>DEV/LCD_xx'cr''lf'] Where xx = 0 to 30
The default is contrast 15.
Lamp Test
KPA-020IN Test Lamps:
Confirmation:
Lamp Test Status:
Confirmation:
>DEV/LAM_xxx'cr''lf']
>DEV/LAM_xxx'cr''lf'] Where: xxx = On or Off