Comtech EF Data KPA - Manual (Page 113)

KPA Ku-Band Indoor Solid-State Power Amplifier Revision 1
Appendix C MN/KPA.IOM
C–17
C.7 Remote Control Using Firmware Version 1.X.X (OLD)
The following index table summarizes the OLD remote control commands – including commands supported by Virtual Addressing Mode as
indicated with an ‘
X ’ in the VAM column – and their location (section and page number) in this appendix.
Old Command Type / Appendix Section Command Display Page VAM
Old Utility Commands C.7.1 Set Time C-18
Set Date C-18
Set Physical Address C-18
Set Baud Rate C-18
Set Parity Rate C-18
Set LCD Contrast C-18
Set LCD Brightness C-18
Lamp Test (KPA-020IN) C-18
Retrieve Equipment type C-19 X
Set Application ID Message C-19
Set Local/ Remote Mode (KPA-040) C-19
Old Configuration Commands C.7.2 Set Amplifier On/OFF C-20 X
Mute/Unmute C-20 X
Set Attenuation C-20 X
Select Auto Fault Recovery C-20 X
Operating Mode Commands C.7.3 Select Auto/Manual Mode C-21
Forced Backup Mode C-21
Select Priority C-21
Old Status Commands C.7.4 Retrieve Configuration Status C-22 X
Retrieve Maintenance C-22 X
Retrieve FET Status C-22 X
Retrieve Utility Status C-24 X
Retrieve Alarm Status C-24 X
Summary Alarm Status C-25 X
Terminal Status Change C-25 X
Packed Configuration Status C-25 X
Packed Maintenance Status C-28 X
Packed FET Status C-28 X
Packed Utility Status C-28 X
Packed Alarm Status C-28 X
Old Stored Alarm Commands C.7.5 Retrieve Total Stored Alarms C-28
Clear All Stored Alarms C-28
List All Stored Alarms C-28