Comtech EF Data KPA - Manual (Page 52)

KPA Ku-Band Indoor Solid-State Power Amplifier Revision 1
Front Panel Operation MN/KPA.IOM
5–8
Select the parameter to configure – Gateway, Address, MAC, or SNMP – using the ◄ ► arrow
keys, then press ENTER.
If Ethernet Config: Gateway is selected:
Ethernet IP Gateway:
192.168.001.002 (◄ ► ▲ ▼)
Edit the IP Gateway Address for the Ethernet M&C port for this unit. Use the ◄ ► arrow
keys to select the character to edit, then the ▲ ▼ arrow keys to edit the value of the digit.
Press ENTER when done.
If Ethernet Config: Address is selected:
Ether IP Address/Range:
192.168.001.002/24(◄ ►,▲ ▼)
Edit the IP Address and Range for the Ethernet M&C port for this unit. Use the ◄ ► arrow
keys to select the character to edit, then the ▲ ▼ arrow keys to edit the value of the digit.
Press ENTER when done.
If Ethernet Config: MAC is selected:
M&C Port MAC Address:
00-06-B0-00-01-06 (ENTER)
This read-only menu shows the unit MAC address. Once the MAC address has been noted,
exit this menu by pressing ENTER or CLEAR.
If Ethernet Config: SNMP is selected:
SNMP:
Community Traps (◄ ► E)
Use the ◄ ► arrow keys to select the parameter to configure: Community or Traps.
If SNMP: Community is selected:
SNMP Community:
Read Write Trap (◄ ► E)
Use the ◄ ► arrow keys to select the community to edit: Read, Write, or Trap.
If SNMP Community: Read is selected:
Read Community: (◄ ► ▲ ▼ E)
public
The user may view or edit the SNMP Read Community string. To edit, first use the ◄
► arrows keys to select the character to edit, then the ▲ ▼ arrows keys to edit that
character. Press ENTER when done.
If SNMP Community: Write is selected:
Write Community:(◄ ► ▲ ▼ E)
private