Comtech EF Data MBT-5000 User Manual
Mbt-5000
Table of contents
Document Outline
- MN-MBT5000_4
.pdf
- INSIDE COVER
- TABLE OF CONTENTS
- TABLES AND FIGURES
- PREFACE
- About this Manual
- Conventions and References
- Safety and Compliance
- Product Support
- Comtech EF Data Headquarters
- Warranty Policy
- Chapter 1. INTRODUCTION
- Chapter 2. INSTALLATION
- Chapter 3. REAR PANEL CONNECTIONS
- 3.1 Cabling Connection Types
- 3.2 MBT-5000 Cabling Connections
- 3.2.1 IF Connector Group
- 3.2.2 Optional Redundancy Groups
- 3.2.3 Utility Connector Group
- 3.2.3.1 ‘J2 | EXT REF IN’ – External Reference Input Connector (BNC-F)
- 3.2.3.2 ‘J8 | EXT REF OUT’ – External Reference Output Connector (BNC-F)
- 3.2.3.3 ‘J9 | 10/100 ETHERNET’ 10/100 BaseT M&C Port (RJ-45)
- 3.2.3.4 ‘P1 | RELAY’ Summary Fault Output Connector (DB-9F)
- 3.2.3.5 ‘J1 | COM 1’ EIA-485/232 Interface Connector (DB-9F)
- 3.3 MBT-5000 Ground and Power Connections
- Chapter 4. UPGRADING FIRMWARE
- Chapter 5. FRONT PANEL OPERATION
- 5.1 Overview
- 5.2 Front Panel Operation
- 5.2.1 SELECT: (Main) Menu
- 5.2.2 SELECT: Config (Configuration) Menu Branches
- 5.2.3 SELECT: Monitor Menu Branch
- 5.2.4 SELECT: Info (Information) Menu Branch
- 5.2.5 SELECT: Utility Menu Branch
- 5.2.6 SELECT: Test Menu Branch
- Chapter 6. ETHERNET-BASED REMOTE PRODUCT MANAGEMENT
- 6.1 Overview
- 6.2 Ethernet Management Interface Protocols
- 6.3 SNMP Interface
- 6.4 Telnet Interface
- 6.5 HTTP (Web Server) Interface
- Chapter 7. SERIAL-BASED REMOTE PRODUCT MANAGEMENT
- Appendix A. BUC-5000x/BDC-5000x MODULE REMOVAL/INSTALLATION
- Appendix B. MBT-5000 REDUNDANCY OPERATION
- BACK COVER