Comtech EF Data MBT-5000 - Manual (Page 112)

MBT-5000 L-Band Up/Down Converter System MN-MBT5000
Serial-based Remote Product Management Revision 4
7–10
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments for
Command or
Response to
Query
Description of Arguments
(Note that all arguments are ASCII numeric codes between 48 and 57)
Response to
Command
(Target to
Controller)
Query
(Instruction
Code and
Qualifier)
Response to query
(Target to
Controller)
Enable
Statistics
Averaging
ESA= 1 byte Command or Query.
Enables or D isables averaging of statistics data at a r ate of once per second for 10 s econd. If
disabled, burst values will be logged instead of averaged values.
0 = Disabled
1 = Enabled
Default Value: 0
Example: <1/ESA=0’cr’
>0001/ESA=’cr’’lf’
ESA=
ESA?
ESA? ESA=x
(Same format as
Command
arguments)
Enable
Statistics
Logging
ESL= 1 byte Command or Query.
Enables or Disables the statistics logging function.
0 = Disable
1 = Enable
Default Value: 0
Example: <1/ESL=1’cr’
>0001/ESL=’cr’’lf’
ESL=
ESL?
ESL? ESL=x
(Same format as
Command
arguments)
Enable
Redundancy
Switch Mode
ESW= 1 byte Command or Query.
Turns ON or OFF the redundancy state, where:
0 = Off
1 = On
Default value: 1
Example: <1/ESW=1’cr’
>0001/ESW=’cr’’lf’
ESW=
ESW?
ESW *
ESW? ESW=x
Retrieve
Firmware
Number
N/A variable length Query only.
Returns the firmware type loaded into the unit.
i = Bulk Image Number (1 or 2)
a = Firmware Image
b = Firmware Revision
c = Firmware Date
N/A FRW?i FRW={CR}Boot:{CR}
abc{CR}Bulki:{CR}abc
{CR}abc
(See Description of
Arguments)