Comtech EF Data MBT-5000 - Manual (Page 82)

MBT-5000 L-Band Up/Down Converter System MN-MBT5000
Ethernet-based Remote Product Management Revision 4
6–4
Type the SNMP Community String into the user-supplied MIB Browser or Network Node
Management software. You must define three Community Strings for SNMP access:
• Read Community default = public
• Write Community default = private
• Trap Community default = comtech
For proper SNMP operation, the MBT-5000 MIB files must be used with the
associated version of the MBT-5000 Remote Router M&C. Refer to the MBT-5000
Firmware Release Notes for information on the required FW/SW compatibility.
6.3.3 SNMP Traps
The MBT-5000 supports both SNMPv1 traps and SNMPv2 notifications. The MBT-5000 has the
ability to send out SNMP traps when certain events occur in the unit. A trap is sent both when a
fault occurs and is cleared. You may configure which style of traps the MBT-5000 sends by using
the MBT-5000SNMPTrapVersion OID.
The following MIB2 SNMPv1traps and SNMPv2 notifications are supported by the MBT-5000:
MIB2 SNMPv1 trap: Authentication Failure 5
MIB2 SNMPv2 notifications: Authentication Failure 1.3.6.1.6.3.1.1.5.5
The following Faults SNMPv1 traps and SNMPv2 notifications are supported by the MBT-5000.
Faults SNMPv1 traps:
mbt5000BaseUnitFaultV1 6247501
mbt5000ConvAFaultV1 6247502
mbt5000ConvBFaultV1 6247503
Faults SNMPv2 notifications:
mbt5000BaseUnitFaultEvent 1.3.6.1.4.1.6247.50.2.1.1
mbt5000ConvAFaultEvent 1.3.6.1.4.1.6247.50.2.1.2
mbt5000ConvBFaultEvent 1.3.6.1.4.1.6247.50.2.1.3