Comtech EF Data MBT-5000 - Manual (Page 40)

MBT-5000 L-Band Up/Down Converter System MN-MBT5000
Rear Panel Connections Revision 4
3–8
3.2.3.3 ‘J9 | 10/100 ETHERNET’ 10/100 BaseT M&C Port (RJ-45)
Chapter 6. ETHERNET-BASED REMOTE PRODUCT MANAGEMENT
This standard RJ-45 female modular jack is used for product M&C using SNMP, Telnet,
and HTTP. It is also used for MBT-5000 firmware updates. A CAT5e UTP cable is used
to connect to an Ethernet hub, router, switch, PC, etc.
Table 3-2. ‘J9 | 10/100 ETHERNET’ Connector Pinout
Pin # Description Direction
1 Tx+ Out
2 TX- Out
3 Rx+ In
4 N/A
5 N/A
6 Rx- In
3.2.3.4 ‘P1 | RELAY’ Summary Fault Output Connector (DB-9F)
This summary fault output connector is a 9-pin Type "D" female connector
(DB-9F). Its mating connector is a DB-9M connector.
Table 3-3. ‘P1 | RELAY’ Connector Pinout
3.2.3.5
Pin # Description
5 GND
9 NC
4 SUMFLT2_NO
8 SUMFLT2_COM
3 SUMFLT2_NC
7 EXT_FLT_IN#
2 SUMFLT1_NO
6 SUMFLT1_COM
1 SUMFLT1_NC
Notes:
1) Pin 1 to Pin 6: Converter A Fault
2) Pin 2 to Pin 6: Converter A OK
3) Pin 3 to Pin 8: Converter B Fault
4) Pin 4 to Pin 8: Converter B OK