Comtech EF Data MIDAS Management Information Base - Manual (Page 57)

Management Information Base , Rev. 1
Appendix A, MIB Listing A-41
nodeRetryCounts40
THALFLONGWORD
}
nodeNodeID OBJECT-TYPE
SYNTAX
TNODEID
ACCESS read-write
STATUS mandatory
DESCRIPTION
"This allows the operator to type the node
ID number."
::= { nodeTableEntry 1 }
nodeName OBJECT-TYPE
SYNTAX
OCTETSTRING30
ACCESS read-write
STATUS mandatory
DESCRIPTION
"This allows the operator to type the name of
the node."
::= { nodeTableEntry 2 }
nodeEnabled OBJECT-TYPE
SYNTAX
BOOLEAN
ACCESS read-write
STATUS mandatory
DESCRIPTION
"To bring node active A node is created in the
disabled state, and does not become active
until it is enabled. Once enabled, the node
will be polled and brought online. On an
enabled (active) node, channels can set up
and respond to calls.
Enabled Node and Channel can't be disabled if
there is an active call related to them
Can't enable/disable a nodet when the
controller mode is not normal"
::= { nodeTableEntry 3 }
nodeStatus OBJECT-TYPE
SYNTAX
TNODEENABLESTATE
ACCESS read-only
STATUS mandatory
DESCRIPTION
"The status of node"
::= { nodeTableEntry 4 }
-- Make sure the modem type is correct for
internal and external such as
-- SNM1010 can't be an external node. For
data/internal, there are IDC-150D,
-- SNM1010. For data/external, there are 100, 150,
300, 6000, 6000, 9000, 2200,
-- 2020, 300L. For ISNN/internal, there are IDC-
150, SNM-1020. For
-- ISDN/external. There are IDC-150, 300, 2200.
For video/internal, there are