Artesyn MVME8100/MVME8110 Installation and Use (September 2014) - Manual (Page 44)

Hardware Preparation and Installation
MVME8100 / MVME8110 Installation and Use (6806800P25G) 44
4. Slide the front bezel of the PMC/XMC into the cut-out from behind. The front bezel
of the PMC/XMC module will be flushed with the board when the connectors on
the module align with the mating connectors on the board.
Note: ENP4 PMC/XMC modules do not have front bezels.
5. Align the mating connectors properly and apply minimal pressure to the PMC/XMC
until it is seated to the board.
6. Insert the two front PMC/XMC mounting screws through the mounting holes on
the bottom side of the board, and then install the top side screws. Tighten the
screws.
Note: Rugged PMC/XMC modules installed on an ENP4 MVME8100 have more than
four mounting screws.
7. Install the board into the appropriate card slot. Make sure that the board is well
seated into the backplane connectors. Do not damage or bend connector pins.