Artesyn MVME8100/MVME8110 Installation and Use (September 2014) - Manual (Page 18)

Introduction
MVME8100 / MVME8110 Installation and Use (6806800P25G) 18
SM Bus  One 512 Kbit user configuration serial EEPROM
 256B SPD EEPROMs
 One 64 Kbit VPD EEPROM
 RTC with battery backup
 Temperature Sensors
 RTM and XMC VPD EERPOMs
FLASH  Two soldered SPI FLASH, 8MB each, switchable for uboot
primary/backup support
 Hardware switch or Software bit write protection for entire logical
bank
 Eight GB eMMC Flash
NVRAM 512 KB MRAM
PCI Express  Two 4X Ports to VXS backplane P0 (muxed with SRIO ports)
 One 8X Port to PMC/XMC Site 1
 One 4X Port to PMC/XMC Site 2
SRIO Two 4X Ports to VXS backplane P0 (muxed with PCIe ports)
USB  One USB 2.0 for front panel I/O
 Two USBs 2.0 for backplane RTM I/O
Ethernet  One 10/100/1000BASE-T Ethernet port to front panel (only in air
cooled variant)
 Two 10/100/1000BASE-T Ethernet channels to P2 / RTM
 Two 1000BASE-BX Ethernet SERDES channels to P0 backplane / RTM
Serial Ports  One RS232/422/485 console port to front panel or P2 / RTM
 Up to 4 RS232/422/485 COM ports to P2/ RTM
VME Bus VME64x and 2eSST
Timers  Eight 32-bit timers in CPU
 Watchdog timer in CPU
PMC/XMC Two PMC/XMC sites with 64-bit PMCIO on Site 1
SATA SSD Option for one 2.5 inch SATA drive (PMC/XMC Site 2)
GPIO Interface Four GPIOs to RTM
Table 1-1 Features List of MVME8100 (continued)
Function Features