Artesyn MVME8100/MVME8110 Installation and Use (September 2014) - Manual (Page 29)

Chapter 2
MVME8100 / MVME8110 Installation and Use (6806800P25G) 29
Hardware Preparation and Installation
2.1 Overview
This chapter provides startup and safety instructions related to this product, hardware
preparation instruction that includes default switch settings. System considerations and
installation instructions for the baseboard, PMC, XMC, and Rear Transition Module (RTM) are
also described in this chapter.
A fully implemented MVME8100 / MVME8110 consists of the baseboard plus:
 Two single-wide or one double-wide PCI Mezzanine Card (PMC) slot for added versatility.
 One rear transition module for support of the mapped I/O from the MVME8100 /
MVME8110 baseboard to the P2 connector.
 Up to two optional XMC cards (in place of PMC modules).
The following table lists the things you need to do before using this board and explains where
you can find the information for performing each step. Be sure to read this entire chapter,
including all Caution and Warning notes, before you begin.
Table 2-1 Startup Overview
Task Page
Unpack the hardware. Unpacking and Inspecting the Board on page 30
Configure the hardware by setting jumpers
on the board and RTM. Configuring the Board on page 34
Install the RTM (VXS1-RTM1) of MVME8100
or MVME8110-RTM of MVME8110 in the
chassis. Rear Transition Module on page 41
Install PMC module (if required). Installing Accessories on page 41
Install XMC module (if required). Installing Accessories on page 41
Install the MVME8100 / MVME8110 in the
chassis. Installing and Removing the Board on page 48
Attach cabling and apply power. Completing the Installation on page 50
Install PIM on transition module (if required). Refer VXS1-RTM1and MVME8110-RTM Installation and Use
manual.
Examine and/or change environmental
parameters. MVME8100 / MVME8110 Single Board Computer
Programmer’s Reference