Artesyn MVME8100/MVME8110 Installation and Use (September 2014) - Manual (Page 100)

Boot System
MVME8100 / MVME8110 Installation and Use (6806800P25G) 100
fatload Load binary file from a DOS file system
fatls List files in a directory (default /)
fdt Flattened device tree utility commands
go Start application at address 'addr'
help Print online help
i2c I2C sub-system
iminfo Print header information for application image
imxtract Extract a part of a multi-image
interrupts Enable or disable interrupts
itest Return true/false on integer compare
loadb Load binary file over serial line (kermit mode)
loads Load S-Record file over serial line
loady Load binary file over serial line (ymodem mode)
loop Infinite loop on address range
md Memory display
memmap Displays memory map
mii MII utility commands
mm Memory modify (auto-incrementing address)
mmc MMC sub system
mmcinfo Display MMC info
moninit Reset nvram, serial#, and write monitor to SPI flash
mtest Simple RAM read/write test
mw Memory write (fill)
nfs Boot image through network using NFS protocol
nm Memory modify (constant address)
pci List and access PCI Configuration Space
pci_info Show information about devices on PCI bus
Table 5-1 MVME8100 / MVME8110Specific U-Boot Commands (continued)
Command Description