Artesyn MVME8100/MVME8110 Installation and Use (September 2014) - Manual (Page 42)

Hardware Preparation and Installation
MVME8100 / MVME8110 Installation and Use (6806800P25G) 42
Installation and Removal Procedure
To begin the installation of the RTM in a chassis, proceed as follows:
1. Turn all equipment power OFF and disconnect the power cable from the AC power
source.
2. Remove the chassis cover as instructed in the equipment user's manual.
3. Remove the filler panel(s) from the appropriate card slot(s) at the rear of the chassis
(if the chassis has a rear card cage).
4. Install the top and bottom edge of the RTM into the rear guides of the chassis.
5. Ensure that the levers of the two injector/ejectors are in the outward position.
6. Slide the RTM into the chassis until resistance is felt.
7. Simultaneously move the injector/ejector levers in an inward direction.
8. Verify that the RTM is properly seated and secure it to the chassis using the two
screws located adjacent to the injector/ejector levers.
9. Connect the appropriate cables to the RTM.
To remove the RTM from the chassis, reverse the procedure and press the red locking tabs (IEEE
handles only) to extract the board.
2.5.2 PMC/XMC Installation
The PMC connectors are placed to support two single-width PMCs or one double-width PMC.
PMC site 1 supports front PMC I/O and rear PMC I/O via the Jn4 connector. PMC 1 I/O is routed
to the VME P2 connector. PMC site 2 only supports front PMC I/O and does not have a Jn4
connector. The PMC 1 Jn4 user I/O signals only support low-current high-speed signals and
thus do not support current-bearing power supply usage.
The user-configured switches are accessible with the PMC/XMCs installed. The onboard PMC
sites are configured to support +3.3 V I/O PMC modules. The onboard PMC sites do not
support +5.0 V I/O PMC modules.