Artesyn MVME8100/MVME8110 Installation and Use (September 2014) - Manual (Page 20)

Introduction
MVME8100 / MVME8110 Installation and Use (6806800P25G) 20
Table 1-2 Features List of MVME8110
Function Features
Processor
(Subset of P5010 features
used on MVME8110)  Freescale QorIQ P5010,1.2Ghz, 15W TDP
 One e500mc-64 core, 512kB L2 cache
 1-Mbyte CoreNet platform cache with ECC
 DDR3 memory controller (max 1333MT/s data rate [1200MT/s for
1.2GHz SKU])
 4x PCIe 2.0 controllers
 2x Serial RapidIO 2.1 controllers
 2x SATA 2.0 controllers
 2x USB 2.0 controllers with integrated PHYs
 5x GbE controllers (SGMII/RGMII))
 1x 10GbE controller
 SD/MMC/eMMC controller
 Local bus controller
 SPI controller (4 CS#)
 2x I2C controllers
 Dual UART
 RAID5/6 engine
 SEC not present
 Programmable interrupt controller
System Memory Up to 4GB Single-Channel DDR3-1333 memory with ECC
SM Bus  One 512 Kbit user configuration serial EEPROM
 256B SPD EEPROMs
 One 64 Kbit VPD EEPROM
 RTC with battery backup
 Temperature Sensors
 RTM and XMC VPD EERPOMs
FLASH  Two soldered SPI FLASH, 8MB each, switchable for uboot
primary/backup support
 Hardware switch or Software bit write protection for entire logical
bank
 Eight GB eMMC Flash
NVRAM 512 KB MRAM