Artesyn MVME8100/MVME8110 Installation and Use (September 2014) - Manual (Page 17)

Chapter 1
MVME8100 / MVME8110 Installation and Use (6806800P25G) 17
Introduction
1.1 Features
The MVME8100 Single Board Computer is a VMEbus board based on the Freescale QorIQ
P5020 processor. It is a high performance 6U VME/VXS board targeted towards high-end
military and industrial automation applications using VMEbus. The MVME8100 is compliant
with the VITA standards VMEbus, 2eSST, and PCI-X.
The MVME8110 is a single core non-VXS version of the MVME8100 board based on Freescale
P5010 QorIQ processor. It runs at 1.2Ghz with 2GB DDR3. The MVME8110 can accommodate
2PMC/XMC.
The MVME8110 has MVME8110-RTM which is a reduced version of the VXS1-RTM1.
Table 1-1 Features List of MVME8100
Function Features
Processor
(Subset of P5020 features
used on MVME8100)  Freescale QorIQ P5020
 Two e5500 Power Architecture cores
 Five Gigabit Ethernet controllers (SGMII and RGMII interfaces)
 Two 64-bit DDR3/3L SDRAM memory controllers with ECC
 Multicore Programmable Interrupt Controller (PIC)
 Four I2C controllers
 Two 4-pin UARTs
 Two 4-channel DMA engines
 Enhanced local bus controller (eLBC)
 Two PCI Express controller/ports
 One Serial Rapid IO controller/ports (SRIO port) v1.3-compliant with
features of v2.1
 Enhanced secure digital host controller (SD/MMC)
 Enhance Serial Peripheral Interfaces (eSPI)
 Two high-speed USB 2.0 controllers with integrated PHYs
System Memory  Two banks of DDR3 SDRAM with ECC
 Total 4 GB (2GB per Bank)
 1333 MHz DDR3 data rate