FeiYu Tech FY-Panda2 Autopilot - Manual (Page 53)

Guilin Feiyu Electronic Technology Co., Ltd.
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyu-tech.com [email protected]
Page 50

If the target waypoint setting when the aircraft work in other working mode (not in
the path navigation mode)
，the air routes will start from the target waypoint when switch
to the path navigation mode.
( 2 ) Operation Of Setting Target Waypoint
Click on “SET POINT” button in page “Route”
in the tool bar on GCS. Input the waypoint number in
the setting box（For example:3） ，click on ― OK ‖ button
to confirm then setting, the command will send to the
autopilot immediately.
 Please input the number which within the effectively waypoint number.
6. Throttle Setting
Pnada2 autopilot can limit the range of the throttle. This function commonly
used in most of the gasoline engine and some special motor.
Operation For Throttle Setting: “Menu”—“Autopilot Setting”—“Throttle Setting”
(1) Set up the lower and upper limit of the throttle lever on the remote control.
(2) Connect the autopilot to the GCS software. Put the throttle lever to the lowest
position on the remote control, click the
―Minimum Throttle‖ to record the throttle lower
limit; Put the throttle lever to the highest position on the remote control, click the
―Maximum Throttle‖ to record the throttle upper limit.
 Please remove the motor before record the maximum throttle, to avoid the
harm cause by the motor rotation.
 After finish the throttle setting, please click the “ Save ” button in” Param1”
page in the tool bar to save the setting.