FeiYu Tech FY-Panda2 Autopilot - Manual (Page 24)

Guilin Feiyu Electronic Technology Co., Ltd.
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyu-tech.com [email protected]
Page 21
12.2 Steps Of ID Number Reset
Step A : Power off the autopilot unit .
Step B : Install the jumper to the signal pin on P1,P2 port ( Refer to the picture 12.1).
Step C : Connect the Autopilot unit to the computer (Ensure power on the unit normally).
Step D : Running the GCS software , select the correct COM port (e.g. COM3),baud
rate:19200,click on ―Connect‖ button.
Step E : Enter the new ID number (e.g.
―01234‖) in the pop-up ID setting dialog box, click
on ―OK‖ button.
Step F : Choose the save path and rename the file in the pop-up dialog box then click on
―Save‖ button to save the log file.
Step G : Select ―Menu---Autopilot Bound‖ on the GCS, the GCS software will prompt
“Autopilot Bound Success！”to remind the resetting successful ( Refer to the
picture 12.2)
Step H : Disconnect the unit, power off the autopilot unit ,uninstall the jumper .
 Please remember the new number for the next connection.
 If the ID number have lost , please reset refer to the “Step A” to “Step H”.
Figure 12.1 Jumper Install