FeiYu Tech FY-Panda2 Autopilot - Manual (Page 51)

Guilin Feiyu Electronic Technology Co., Ltd.
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyu-tech.com [email protected]
Page 48
Step K: The Post processing
1) Power off the aircraft after landing, turn off the RC unit and GCS, take back the
aircraft.
2) Read the image from the camera, the POS information from the PandaⅡ autopilot,
then post processing.
Appendix
Appendix A: Introduction For Other Functions And
Settings
1.
“Click Point Flight” Working Mode
Panda
Ⅱ autopilot can enter the ―Click Point Flight‖ mode under any working mode.
Click on the ―Set ClickP‖ button in page ―Control‖ in tool bar on the GCS, then click the
flight target point on the map, the aircraft will fly to the target point directly with the current
altitude then hovering and waiting for the next command. Click the ―Cancel‖ button in
page ―Control‖ on GCS to exit the ―Click Point Flight‖ mode or you can switch the SW2 to
any navigation mode to exit.
2. Route Loop Function
The default path navigation working mode is not circulation, the aircraft will hovering
at the last waypoint and waiting for the next command when the aircraft finish the route
flying. Click on the ―Not Loop‖ button in page ―Control‖ on the GCS to cancel the the
default setting .The button will display ―Loop‖ after change the setting. If the ― Path
Navigation ‖ fly with ―Loop‖ the aircraft will auto repeat the waypoint. When the aircraft
fly over the last waypoint it will back to the first waypoint for lying again.
 After finish the parameter setting, please click the “Save” button in page
“Param1” in the tool bar to save the setting.