Cisco VPN 3002 - Manual (Page 197)

13-9
VPN 3002 Hardware Client Reference
OL-1893-01
Chapter 13 Monitoring
Monitoring | System Status
Refresh
To update the screen and its data, click Refresh . The date and time indicate when the screen was last
updated.
VPN Client Type
The type, or model number, of this VPN 3002 hardware client.
Bootcode Rev
The version name, number, and date of the VPN 3002 bootcode software file. When you boot or reset
the system, the bootcode software runs system diagnostics, and it loads and executes the system software
image. The bootcode is installed at the factory, and there is no need to upgrade it. If an engineering
change requires a bootcode upgrade, only Cisco support personnel can do so.
Software Rev
The version name, number, and date of the VPN 3002 Hardware Client system software image file. You
can update this image file from the Administration | Software Update screen.
Up Since
The date and time that the VPN 3002 was last booted or reset.
RAM Size
The total amount of SDRAM memory installed in the VPN 3002.
Disconnect Now
Disconnects the tunnel.
Connect Now
Connects the tunnel.
Assigned IP Address
The IP address assigned to the VPN 3002 by the central-site VPN Concentrator when PAT mode is
enabled. This field is not displayed when the VPN 3002 is running in Network Extension mode, because
the central-site VPN Concentrator does not assign an IP address to the VPN 3002 in Network Extension
mode.