Cisco VPN 3002 - Manual (Page 105)

9-9
VPN 3002 Hardware Client Reference
OL-1893-01
Chapter 9 Events
Configuration | System | Events | Classes
Figure 9-3 Configuration | System | Events | Classes Screen
To configure default event handling, click the highlighted link that says “Click here to configure general
event parameters.”
Configured Event Classes
The Configured Event Classes list shows the event classes that have been configured for special
handling. The initial default entry is MIB2TRAP, which are SNMP MIB-II events, or “traps,” that you
might want to monitor with an SNMP network management system. Other configured event classes are
listed in order by class number and name. If no classes have been configured for special handling, the
list shows --Empty--.
Add/Modify/Delete
To configure and add a new event class for special handling, click Add. See Configuration | System |
Events | Classes | Add.
To modify an event class that has been configured for special handling, select the event class from the
list and click Modify. See Configuration | System | Events | Classes | Modify.
To remove an event class that has been configured for special handling, select the event class from the
list and click Delete. There is no confirmation or undo. The Manager refreshes the screen and shows the
remaining entries in the list.
Reminder:
The Manager immediately includes your changes in the active configuration. To save the active
configuration and make it the boot configuration, click the Save Needed
icon at the top of the Manager
window.