Cisco VPN 3002 - Manual (Page 136)

12-10
VPN 3002 Hardware Client Reference
OL-1893-01
Chapter 12 Administration
Administration | Access Rights | Administrators
Administrator
The VPN 3002 has three predefined administrators:
• admin = System administrator with access to, and rights to change, all areas. This is the only
administrator enabled by default; in other words, this is the only administrator who can log in to,
and use, the VPN 3002 Hardware Client Manager as supplied by Cisco.
• config = Configuration administrator with access rights to Quick Configuration and monitoring
management options only.
• monitor = Monitor administrator with rights to monitoring management options only.
Note The VPN 3002 saves Administrator parameter settings from this screen in nonvolatile memory, not
in the active configuration (CONFIG) file. Thus, these settings are retained even if the system loses
power. These settings are also retained even if you reboot the system with the factory configuration
file.
Password
Enter or edit the unique password for this administrator. Maximum is 31 characters. The field displays
only asterisks.
Note The default password that Cisco supplies is the same as the username. We strongly recommend that
you change this password.
Verify
Re-enter the password to verify it. The field displays only asterisks.
Enabled
Check the box to enable, or clear the box to disable, an administrator. Only enabled administrators can
log in to, and use, the VPN 3002 Hardware Client Manager. You must enable at least one administrator,
and you can enable all administrators. By default, only admin is enabled.
Apply/Cancel
To save this screen settings in nonvolatile memory, click Apply. The settings immediately affect new
sessions. The Manager returns to the Administration | Access Rights screen.
To discard your settings or changes, click Cancel. The Manager returns to the Administration | Access
Rights screen.