Cisco VPN 3002 - Manual (Page 117)

10-3
VPN 3002 Hardware Client Reference
OL-1893-01
Chapter 10 General
Configuration | System | General | Time and Date
Configuration | System | General | Time and Date
This screen lets you set the time and date on the VPN 3002. Setting the correct time is very important
so that logging information is accurate.
Figure 10-3 Configuration | System | General | Time and Date Screen
Current Time
The screen shows the current date and time on the VPN 3002 at the time the screen displays. You can
refresh this by redisplaying the screen.
New Time
The values in the New Time fields are the time and date on the browser PC at the time the screen
displays. Any entries you make apply to the VPN 3002, however.
In the appropriate fields, make any changes. The fields are, in order: Hour : Minute : Second Month /
Day / Year Time Zone. Click the drop-down menu buttons to select Month, and Time Zone. The time
zone selections are offsets in hours relative to GMT (Greenwich Mean Time), which is the basis for
Internet time synchronization. Enter the Year as a four-digit number.
Enable DST Support
To enable DST support, check the box. During DST (Daylight-Saving Time), clocks are set one hour
ahead of standard time. Enabling DST support means that the VPN 3002 automatically adjusts the time
zone for DST or standard time. If your system is in a time zone that uses DST, you must enable DST
support.
Apply/Cancel
To apply your time and date settings, and to include your settings in the active configuration, click
Apply. The Manager returns to the Configuration | System | General screen.