Cisco VPN 3002 - Manual (Page 124)

11-6
VPN 3002 Hardware Client Reference
OL-1893-01
Chapter 11 Policy Management
Configuration | Policy Management | Traffic Management | PAT
PAT
To configure PAT (Port Address Translation) click PAT .
Configuration | Policy Management | Traffic
Management | PAT
The Configuration | Policy Management | Traffic Management | PAT screen displays.
Figure 11-3 Configuration | Policy Management | Traffic Management | PAT Screen
PAT mode provides many-to-one translation; that is, it translates many private network addresses to the
single address configured on the public network interface.
Enable
To enable PAT, click Enable.
Configuration | Policy Management | Traffic Management |
PAT | Enable
This screen lets you enable or disable PAT, which applies PAT to all configured traffic flowing from the
private interface to the public interface.
Figure 11-4 Configuration | Policy Management | Traffic Management | PAT | Enable Screen