Action, Configuration – Cisco VPN 3002 User Manual
Page 132
12-6
VPN 3002 Hardware Client Reference
OL-1893-01
Chapter 12 Administration
Administration | System Reboot
Figure 12-6 Administration | System Reboot Screen
Action
Click a radio button to select the desired action. You can select only one action.
•
Reboot = Reboot the VPN 3002. Rebooting terminates all sessions, resets the hardware, loads and
verifies the software image, executes system diagnostics, and initializes the system. A reboot takes
about 60-75 seconds. (This is the default selection.)
•
Shutdown without automatic reboot = Shut down the VPN 3002; that is, bring the system to a halt
so you can turn off the power. Shutdown terminates all sessions and prevents new user sessions (but
not administrator sessions). While the system is in a shutdown state, the
SYS
LEDs blink on the front
panel.
•
Cancel a scheduled reboot/shutdown = Cancel a reboot or shutdown that is waiting for a certain
time or for sessions to terminate. (This is the default selection if a reboot or shutdown is pending.)
Configuration
Click a radio button to select the configuration file handling at reboot. These selections apply to reboot
only. You can select only one option.
•
Save the active configuration at time of reboot = Save the active configuration to the
CONFIG
file,
and reboot using that new file.
•
Reboot without saving the active configuration = Reboot using the existing
CONFIG
file and
without saving the active configuration. (This is the default selection.)