EVCO c-pro nano RACK - Manual (Page 28)

C-PRO NANO RACK E C-PRO MICRO RACK APPLICATION MANUAL
Page 28
Installer Menu
The installer menu is of level 3, it is then necessary to insert the installer level or builder password in order to
see/modify the parameters in this branch.
reG1 ( CIRCUIT 1 SETTINGS Menu)
reG2 ( CIRCUIT 2 SETTINGS Menu )
CoMP (COMPRESSORS Menu)
FAn (FANS Menu)
SEcu (SECURITIES Menu )
Par (VARIOUS PARAMETERS Menu)
MAP (PARAMETERS MAPS Menu )
PSd3 (INSTALLER Password Menu )
In installer menu there are all the parameters concerning the configuration of all the functions (alarms,
adjustments, logics, rotation type, … ) of the machine.
In ADJUSTMENTS it is possible to adjust/see the parameters concerning the sideband and neutral zone
thermoregulations for compressors and fans.
In COMPRESSORS and FANS menu it is possible to set the parameters concerning devices management:
⋅
rotation
⋅
logic of divisions
⋅
times…
In SECURITIES menu there are all the parameters regarding the alarms and securities management for
compressors and fans
⋅
habilitations
⋅
delays in signalling
⋅
reinforcement type…
In VARIOUS PARAMETERS there are other general parameters regarding Modbus communication
management, the bottom values for transducers and other habilitations that can be adjusted.
The PARAMETERS MAPS menu can be reached only from the machine in OFF status. In this menu it is
possible to restore the factory parameters and to save or reload the parameters from a programming flashdrive
key. After every operation it is necessary to switch off and switch on again the tool.