Comtrol ES7510 - Manual (Page 151)

RocketLinx ES7510 User Guide: 2000544 Rev. B Network Redundancy (CLI) - 151
Configuration Using the Command Line Interface (CLI)
This table provides detailed information about the CLI command lines for network redundancy.
RSTP
Enable Switch(config)# spanning-tree enable
Disable Switch(config)# spanning-tree disable
RSTP mode
Switch(config)# spanning-tree mode rapid-stp
SpanningTree Mode change to be RST(802.1w).
STP mode
Switch(config)# spanning-tree mode stp
Spanning-Tree Mode change to be STP(802.1d).
Priority
Switch(config)# spanning-tree priority
<0-61440> valid range is 0 to 61440 in multiple of 4096
Switch(config)# spanning-tree priority 4096
Max Age
Switch(config)# spanning-tree max-age
<6-40> Valid range is 6~40 seconds
Switch(config)# spanning-tree max-age 10
Hello Time
Switch(config)# spanning-tree hello-time
<1-10> Valid range is 1~10 seconds
Switch(config)# spanning-tree hello-time 2
Forward Delay
Switch(config)# spanning-tree forward-time
<4-30> Valid range is 4~30 seconds
Switch(config)# spanning-tree forward-time 15
algorithm-timer
Switch(config)# spanning-tree algorithm-timer
<4-30> value of forward-delay
Switch(config)# spanning-tree algorithm-timer 15 20 2
Port Path Cost
Switch(config-if)# spanning-tree pathcost
method the pathcost is used to determine the best path between
devices
Switch(config)# spanning-tree pathcost method
long specifies 32-bit based values that range from 1-200,000,000
short specifies 16-bit based values that range from 1-65535
Switch(config-if)# spanning-tree pathcost 200000
Port Priority
Switch(config-if)# spanning-tree port-priority
<0-240> Number from 0 to 240, in multiple of 16
Switch(config-if)# spanning-tree port-priority 128
Link Type -
Auto Switch(config-if)# spanning-tree link-type auto
Link Type - P2P Switch(config-if)# spanning-tree link-type point-to-point