Power over ethernet (cli) – Comtrol ES7510 User Manual
Page 145
RocketLinx ES7510 User Guide: 2000544 Rev. B
Power over Ethernet (CLI) - 145
Configuration Using the Command Line Interface (CLI)
Power over Ethernet (CLI)
Power over Ethernet is one of the key features of ES7510. It is fully IEEE 802.3af compliant, and supports
IEEE 802.3at, including two-event and LLDP classification. The ES7510 supports up to 8-Port PoE injectors
in Port 1 to Port 8, each port with the ability to deliver 30W of power.
For more information or to use the web user interface, see
This table provides detailed information about the CLI commands for PoE control.
PoE System Status
Display
Switch> enable
Switch# show poe system
PoE System
PoE Admin : Enable
PoE Hardware : Normal
PoE Input Voltage : 47.700 V
Output power : 0.00 Watts
Power Budget :
Budget : 80 Watts
Power Budget Warning Level : N/A
Utilization : 0 %
Event : Normal
PoE Interface Status
Display
Switch> enable
Switch# show poe interface
[IFNAME] Interface name
Switch# show poe interface fa1
Interface fastethernet1 (POE Port 1)
Control Mode : User (Disable)
Powering Mode : 802.3af
Operation Status : Off
Detection Status : Valid
Classification : N/A
Priority : Highest
Output Power : 0.0 Watts, Voltage : 0.0 V, Current : 0 mA
Power Budget :
Budget : 32.0 Watts, effective 0 Watts
Power Budget Warning Level : N/A
Utilization : 0 %
Event : Normal