Toshiba IK-WB11A - Manual (Page 53)

5)Configure each of the other settings
Input Type (alarm notification conditions)
This is the setting for external alarm input method. Set the conditions
depending on kinds of sensor you are using.
Normal Opened (NO)
Normal Closed (NC)
Non-Voltage point method. It opens the point
(circuit) when nothing is happening (normal), and
closes when alarm has generated.
Non-Voltage point method. It closes the point
(circuit) when nothing is happening (normal), and
opens when alarm has generated.
^ The default setting is "Normal Opened (NO)."
Associate to P/T Operation (camera operation when an
external alarm went off)
OFF
Preset
: The lens will not move even if an alarm has generated.
: The lens moves to the preset position specified for "Preset
No."
Auto Patrol : The lens moves to each of the preset positions in order.
(Available Settings when "Preset" is Selected Above)
Preset No. (number of the preset which shows the camera
images when an external alarm has gone off)
1 to 10
^For example, you can select the preset number of a lens position
for showing the area around a sensor or other device attached to
a door.
Resume Function (returns the lens to the position where it was
when the alarm went off)
ON When a fixed period of time elapses after the lens moved
in response to an alarm, the lens returns to the position
where it was when the alarm went off.
OFF After the lens moved in response to an alarm, the lens
stays still at the position of the selected preset.
Resume Time (period of time until the Resume function starts)
10, 30, 60 seconds
^NOTE
• The "Preset No.," "Resume Function," and "Resume Time" settings are only
valid when "Preset" is selected for "Associate to P/T Operation."
- I
o
a .
c
m 0 )
3"
(D
-1
№