Toshiba IK-WB11A - Manual (Page 106)

0°o
Before Calling Service Personnel...
-1
o
a.
c
o
o
3
Q)
3
Q. :
OtRl
■O •
CD I-
Q) (0
o
3
3
o n
CO
(D
c
■D
Symptom
There is no IP
address of
your network
camera on
The Camera
Finder s
Network
Camera List.
(Part 1)
006
Can't connect
the camera
and the
wireless LAN.
Cause How to Manage
LAN Connection
Wired Wireless
•The power of the
camera is not turned
on.
•Turn on the power. O O
•LAN cable is not
connected.
•Connect the LAN cable of the
camera to a hub or router in the
right way.
•Be sure to turn on the power of
the hub and router.
O
•The order of
connecting LAN
cable and turning on
the power of the
camera is not right.
•If you turn on the camera before
connecting the LAN cable, the
camera perceives it as wireless
LAN mode. Connect the LAN
cable to the hub or router first and
then, turn on the camera again.
^Be sure to turn on the power of
the hub and router.
O
•The order of
connecting LAN
cable and turning on
the power of the
camera is not right.
•If you connect the LAN cable to
the powered on hub or router first,
the camera perceives it as wired
LAN mode. Even if you disconnect
the cable after the camera started
as the wired, it will not turn to
wireless mode. In this case, turn
on the power of the camera again
when disconnecting the LAN cable.
O
•LAN cable is not
connected to the PC.
•Connect the LAN cable to the PC
in the right way.
O
•Wireless LAN setting
is not right.
•Confirm that the wireless LAN
setting of the camera and your
wireless LAN environment are the
same.
O
•IP address of the PC
is not configured. (^
page 75)
•Configure the IP address of your
PC correctly. (^ page 43)
O O
•There may be other
wireless devices
near your PC or the
camera.
•The network camera uses 2.4GHz
radio range. If you have microwave
near the PC or the camera, or if
you are using something like
Bluetooth TM , it would be difficult to
have good wireless connection.
•Try setting other wireless
channels which has better
connection.
O