6). tighten the new band unit, 7). attach the 3 unit terminal plate, Attach the connector – Kenwood TM-741A User Manual
Page 73: Replace the cases
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

(6). Tighten the new band unit.
® Tighten the 2 side
screws to secure the
new band unit in
place.
d) Insert the 2 long
screws.
(3) Tighten the 2 long
screws while holding
the nuts and lock
rings from the
opposite side.
(7). Attach the 3 unit terminal plate.
® Insert the 3 unit
terminal plate.
(2) Tighten the 6 screws
from each side of the 3
units.
Replace the cooling fan assembly.
Align the fan cable
with the slot of the
rear case.
Replace the cooling
fan assembly.
Tighten the 4 screws.
Slot
Attach the connector.
Attach the connector.
Route the cable in the
slot of the chasis.
Attach the supplied 2
sheet on the cable.
®. Replace the cases.
QAttach the top and bottom case.
©Tighten the 4 screws to secure the top case.
©Tighten the 4 screws to secure the bottom case.
©Tighten the 4 screws of the both sides.
73