Kenwood TM-741A - Manual (Page 15)

I Function key Assignments
Press the F key for longer than 1 second so that the
key indicator begins to flash, then press the key
below.
Key Function Refer to
F 1 Sec, VFO
Change Scan Hold/
Resume mode
P.36 4-5-2
F 1 Sec, MR Memory channel lockout P.40 4-5-10
F 1 Sec, MHz
Automatic Power off functior
will turn on or off
P.52 4-10
F 1 Sec, CALL
The lower limit of the
programmable VFO
P.23 4-2-4
F 1 Sec, SHIFT
The upper limit of the
programmable VFO
P.23 4-2-4
F 1 Sec,
TONE
Tone frequency selection P.42 4-6-3
F 1 Sec, REV Beep tone level adjustment P.53 4-12
F 1 Sec, DTSS DTSS code selection P.44 4-7-2
F 1 Sec, LOW Time-out timer on or off P.28 4-3-3
F 1 Sec,
CONT SEL
Select receive detection
output band from the
microphone connector
P.18 4-1
F 1 Sec,
BANDSEL
Band on or off P.25 4-2-6
• Press and hold the F key, then the key DClow.
Key Function Refer to
F+ VFO
Enter the programmable scan
lower frequency limit
P.38 4-5-4
F+ MHz
Enter the programmable scan
upper frequency limit
P.38 4-5-4
F+ MR
Clear the displayed memory
channel data
P.35 4-4-8
F+ TONE Bank status display P.32 4-4-7
F+ DTSS DTSS delay time selection P.45 4-7-4
F+ LOW Memory consolidation P.32 4-4-7
F+
CONT SEL
Automatic Memory scan P.39 4-5-9
F+
BAND SEL
Clear Memory Bank P.35 4-4-8
F+ PIT TX Alert P.27 4-3-2
• Press and hold the key below and turn on the power
switch.
Key Function Refer to
MR +
Power ON
Memory reset of all bands P.29 4-4-2
F+ BANDSEL
+ Power ON
Memory reset of a band P.29 4-4-2
15