Kenwood TM-741A - Manual (Page 38)

The lower- and upper-limit frequencies of a program
scan are set in advance for each band.
•Lower and the Upper Scan Limits Entry
Display the lower frequency limit, press and hold the F
key then press the VFO key.
Display the upper frequency limit, press and hold the F
key then press the MHz key.
•Operation
1. Adjust the SQL control to the threshold point.
2. Select a frequency between the two programmed scan
limits.
3. Press the VFO key for longer than 1 second. The MHz
indicator will begin flashing as a visual reminder the
transceiver is scanning.
4-5-4. Programmable Band Scan
NOTE
When the current frequency step is different from the
upper or lower limit frequency step, the frequencies
are scanned from the lower limit and the step
depends on that of the lower frequency limit.
Continue to 4-5-3 step 4.
4-5-5. MHz Scan
1. Adjust the SQL control to the threshold point.
2. Press the MHz key during band scan or
programmable band scan. The MHz indicator will
begin flashing as a visual reminder the transceiver is
MHz scanning.
3. Scanning will start in an upwards direction over a 1
MHz range.
Continue to 4-5-3 step 3
4-5-6. Memory Channel Scan
NOTE
1. Only those memory channels that have data
entered, and that have not been locked out it will
be scanned.
2. Scan does not start unless there are 2 channels
that have data entered.
The memory in a band and bank can be scanned.
1. Adjust the SQL control to the threshold point.
2. •Memory scan in band
Press the CONT SEL key or the BAND SEL key of
the band to change the operating band.
Press the MR key for longer than 1 second to initiate
memory scan of the band.
•Memory scan in bank
When the band is in the memory channel mode press
the CONT SEL key for longer than 1 second to
initiate memory bank scan.(The operation band
changes at the same time.)
Continue to 4-5-3 step 4.
38