All band mode, Individual band mode, 4-3. memory channels – Kenwood TM-741A User Manual
Page 30: Memory channels
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

VFO RESET
The microprocessor’s VFO memory (without memory
channels 1~100, CALL channel, and paging memory
channel) will be initialized.
ALL BAND mode
1. Turn the Power switch off.
2. Press and hold the VFO key and turn on the
POWER switch.
3. Release the VFO key.
INDIVIDUAL BAND mode
1. Turn the Power switch off.
2. Press and hold the VFO key and the BAND SEL
key for the band, then turn on the POWER switch.
3. Release both keys.
4-4-3. Memory Channels
The transceiver has 100 memory channels for each
band. The memories are divided into five banks of 20
sis in each.(See
Memory Banks
Page 32)
BANK
1 :
CH 1
— 20
BANK
2 :
CH 21
-40
BANK
3 :
CH 41
— 60
BANK
4 :
CH 61
-80
BANK
5 :
CH 81
— 100
Each Memory channel is capable of storing the following
information:
4-4-4. Memory Contents
Normal
channel
Odd Split
channel
RX Frequency
o
o
TX Frequency(^)
NA
o
Tone
(CTCSS)
Frequency
(With the optional CTCSS unit TSU-7)
o
o
Tone
(CTCSS)
status
o
o
Frequency step
o
o
Shift status (ssi)
o
NA
REV status (^)
o
NA
DTSS code ,DTSS status
o
O
Last operation paging memory
number
(With the optional unit DTU-2)
o
o
O:
Can be stored in Memory.
NA: Cannot be stored in Memory.
(«) When a separate TX frequency is entered in a
memory, the shift state and reverse on/off
programming is removed from the memory.
30