Kenwood TM-741A User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Fig.l
2. Turn on the Power Supply, then turn on the
transceiver’s POWER switch. The display should
light after 1 second. Fig.l shows examples of
frequencies that will appear on the various models.
The frequencies shown above are the default
frequencies after a microprocessor reset. If the
display shows incomplete data or you think the
displayed frequency is in error you should reset the
microprocessor. ( Memory Initialization on page 29 )
Perform the following steps for each band.
so that the operating band indicator lights (green).
Rotate the VOL control clockwise until a signal or
noise is heard coming from the speaker.
4. Rotate the tuning control or press the microphone
UP/DWN switches to select an open channel.
5. Rotate the SQL control clockwise until the noise just
disappears and the BUSY indicator turns off. This
point is known as the Squelch Threshold point.
6. Select the desired operating frequency using the
microphone or tuning control. When a signal is
received the S-meter will deflect and the BUSY
indicator will turn on.
21