B g r, Lohs – Kenwood TM-741A User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
►Microphone terminal connection
4-1-3. Display Panel
(Front view)
Receive audio for
the selected TX
band
(100mV/l0kn)
Receive Audio Output Band Selection (RD) connector
The RD terminal will supply an audio signal during
receive on the same band that has been selected for
transmit. Press the F key for longer than 1 second, and
then press the CONT SEL key for the desired band. An
indicator will appear in the frequency display of the
selected band.
/ -----
lOHS
L,
r r n n o
W
l
/ .
u
u
u
Receive Audio output display
The 100 kHz dot in the band lights
/1
o o ^
c
LLCfO U.U:U.U
(
9
>
^ B g r
B U S Y
S S R F
—1
— B — a
(p
—+
)REV
®CTCSS
)DTSS
)CO
IlllllllllllllrS^
L , M
(ij)
Indicates the TX band.
Displays the selected transmitter offset
direction.
On when the Reverse function has been
activated.
With the optional CTCSS unit TSU-7: On
when the Tone Decode function is active.
On when the Tone Encode function is
active.
With optional DTU-2
On when the DTSS function is active.
On when Carrier Operated scan is
selected.
On when the Tone Alert function is
active.
18